How to Setup a Kegerator to Serve Nitro Coffee




This video walks you through setting up a kegerator with a stout faucet for serving “nitro coffee”. The video will walk you through setting up a kegerator from start to finish and discusses the type of gas needed and the serving pressure to properly serve cold brew coffee out of a stout faucet – more commonly referred to as “nitro coffee”.

In the video, you’ll learn how to:

– Assemble the kegerator hardware
– Plumb the gas and beverage lines
– Mount the draft tower
– Install the stout faucet
– Connect the gas and liquid lines to the keg
– Type of gas to use for nitro coffee
– Pressure to use when serving nitro coffee
– How to pour with a stout faucet

Have any questions? Let us know in the comments below, or visit our blog:

Subscribe to our YouTube channel:

Previous Run a successful and profitable tea shop - introduction
Next Meetings Imagined - Promote

10 Comments

  1. Tom Greene
    June 12, 2015
    Reply

    Any chance you could do a video on adding another CO2 line? I see you have the newer models of the Edgestar with the large vertical gap where the CO2 comes in.. 🙂

  2. Phewy
    June 25, 2015
    Reply

    I love this!  
    Is there an issue if you were to go between coffee and Guinness?

  3. John Aitchison
    October 30, 2015
    Reply

    Bad information. Go with straight Nitrogen, CO2 will give the coffee a sharp, bitter flavor. Also, run your pressure higher; 40-50 psi is better. Most of all, don't buy an Edgestar. Drilling your own holes for the tower? What a POS.

  4. Robert Ross
    November 3, 2015
    Reply

    Do you guys have a smaller tank as shown in the video for the beer gas mixture. I am only finding larger tanks.

  5. asheatstheworld
    March 16, 2016
    Reply

    the gas solution is in that one tank? No additional tanks needed? Thanks!

  6. DryRice
    March 16, 2016
    Reply

    As a product it should have pre drilled holes for the stout tap instead of it being another tiresome job for the buyer. :/

  7. Narciso Queiruga
    August 9, 2016
    Reply

    Only criticism is that this video suggests to use a co2 nitrogen mix. Co2 makes coffee bitter. You need straight nitrogen and a double dip tube keg.

  8. Patrick Yeh
    December 5, 2016
    Reply

    Does it works with latte? Or coffee only?

  9. aarocka11
    December 7, 2016
    Reply

    Hey am I the only one who thinks having to drilling holes in a kegerator is bullshit. Like they had to manufacture minifridges with a massive gaping hole. Why aren't the 4 holds pre drilled. If I have to use an electric drill to install a kegerator I might as well buy a hole saw and a much cheaper minifridge. Am I missing something?

  10. Cold Brew Avenue
    April 28, 2017
    Reply

    These units now have pre-drilled holes with countersunk nuts in the top, so you simply have to mount the tower with 4 screws. No more drilling!

Leave a reply

Your email address will not be published. Required fields are marked *